AC METERING COT
– 11 –
A2008-10
AC METERING COT
PROGRAMMING
For call charge, refer to the followings.
STATION MESSAGE DETAIL RECORDING (SMDR)
page 477
or CALL INFORMATION SYSTEM (CIS)
page 97
(1) When metering pulses are detected by a C.O. trunk.
(2) When metering pulses are detected by a DTI trunk. (DTI Metering)
In addition to the DTI assignment (30-DTI) in the “Direct Digital Interface (DDI)”, do the
following programming.
DESCRIPTION DATA
Specify the application of answer signal
from the distant office for outgoing con-
nection.
•
(1)
(2)
Y=04
00-63: Trunk Route No.
0: Answer Signal arrives
(12 KHz, 50 Hz Metering Signal)
(C.O. line)
•
(1)
(2)
Y=42
00-63: Trunk Route No.
0: Metering
DESCRIPTION DATA
Assign the data so as to detect metering
pulses.
•
(1)
(2)
Y=42
00-63: Trunk Route No.
0: Metering
START
END
CM35
START
CM35
A
To Next Page
Loading...
