MESSAGE REGISTRATION
– 676 –
A2668-10
MESSAGE REGISTRATION
PROGRAMMING
The SMDR is used to provide Message Registration information to a call accounting system.
Refer to STATION MESSAGE DETAIL RECORDING (SMDR).
page 477
To provide Message Registration on PMS:
DESCRIPTION DATA
Provide the system with SMDR service for
tandem calls.
(1)
(2)
040
0: Available
Assign the Pseudo-Answer signal function
when the answer signal (Battery Reversal)
has not been detected within the time as-
signed by CM41 Y=0>03 after making an
outgoing trunk call.
NOTE: This data is effective when CM35
Y=04 is set to “1”.
(1)
(2)
123
• For Australia
0 : To send
1 : Not sent
• For other countries
0 : Not sent
1 : To send
Provide SMDR service for outgoing calls
to required stations.
•
(1)
(2)
Y=06
X-XXXX: Station No.
1 : To provide
Provide SMDR service for incoming calls
to required stations.
•
(1)
(2)
Y=05
X-XXXX: Station No.
0 : To provide
1 : Not provided
Specify the type of answer signal from dis-
tant office in outgoing connection for each
trunk route.
•
(1)
(2)
Y=04
00-63: Trunk Route No.
2 : Answer signal arrives from Tie
Line/ISDN
7 : Answer signal does not arrive
Provide SMDR service for outgoing calls
to required trunk routes.
•
(1)
(2)
Y=14
00-63: Trunk Route No.
1 : To provide
CM35
START
CM08
CM13
A
To Next Page
Loading...
