NEC NEAX 2000 - Incoming Call Identification

INCOMING CALL IDENTIFICATION
– 276 –
A2270-10
INCOMING CALL IDENTIFICATION
PROGRAMMING
DESCRIPTION DATA
Specify the Incoming Call Identification
(ICI) Key to which Incoming Call from each
trunk route terminates.
•
(1)
(2)
Y=15
00-63: Trunk Route No.
ICI Key
00-07: C.O. Incoming Call 0-7
40-47: Tie Line Incoming Call 0-7
Assign the ATT Call Selection Keys re-
quired on the ATTCON.
The following ATT Call Selection Keys are
initially set.
Key No. Data Description
16 F6061 Recall
17 F6060 Operator Call
18 F6000 C.O. Incoming 0
•
(1)
(2)
Y=00
ATTCON No. (E000-E007) + + Key
No.
F60XX
XX: 00-07: C.O. Incoming Call 0-7
40-47: Tie Line Incoming Call 0-7
50-53: Special Operator Call 0-3
54: Priority Call 0
55: Priority Call 1
56: Emergency Call
60: Operator Call
61: Recall
62: Serial Call
63: Call Forwarding-Don’t Answer
64: Call Forwarding-Busy Line
65: Call Forwarding-Intercept
66: Off Hook Alarm
67: Interposition Calling/Transfer
Assign the required Attendant Call Selec-
tion keys and Function keys to each
DESKCON, according to the key label.
•
(1)
(2)
Y=00
ATTCON No. (E000-E007) + + Key
No.
F6000-F6067: Type of Calls to be as-
signed
F6100-F6245: Functions to be as-
signed
CM90
START
CM35
A
LOOP1 LOOP2 LOOP3 LOOP4 LOOP5 LOOP6
01
ANS
97
RLS
96
1 2 3
4 5 6
7 8 9
* 0 #
SRC DEST
HOLD CANCEL
13 14
15 16
17 18
90 91
92 93
94 95
07
02 03 04 05 06
08
09 10 11 12
MODE PROG
,
,