NEC NEAX 2000 - BOSS-SECRETARY-MESSAGE WAITING LAMP CONTROL-D Term

BOSS-SECRETARY-MESSAGE WAITING LAMP CONTROL-D
term
– 72 –
A2066-10
BOSS-SECRETARY-MESSAGE WAITING LAMP CONTROL-
D
term
PROGRAMMING
In addition to the programming of “BOSS-SECRETARY TRANSFER-D
term
” page 74 , do the
following programming.
HARDWARE REQUIRED
D
term
and DLC card
DESCRIPTION DATA
If the Boss station is a Single Line Tele-
phone with MW lamp, provide the Mes-
sage Waiting service to the station.
•
(1)
(2)
Y=03
X-XXXXXXXX: Boss Station No.
0: To provide
Assign the MW SET/MW RESET keys to
the Secretary’s D
term
.
•
(1)
(2)
Y=00
My Line No. of Secretary + + Key
No.
F0040: MW Set
F0041: MW Reset
If the Boss station is a D
term
, assign a MW
Lamp to the Boss’ D
term
.
•
(1)
(2)
Y=00
My Line No. of Boss + + Key No.
F1005: MW Lamp
Assign the access code for MW Set/MW
Reset to the secretary’s D
term
, if required.
•
(1)
(2)
Y=0-3 Numbering Group 0-3
X-XXXX: Access Code
A040: MW Set
A041: MW Reset
Whether Message Waiting/Message Re-
minder is reset (turning the MW Lamp off)
irrespective of answering of calling station
when the called station calls to retrieve the
message.
(1)
(2)
234
0 : Available
1 : Not available (Reset by answering
of calling station)
Specify the MW Lamp indication pattern
for D
term
.
(1)
(2)
294
0 : Flashing (60 IPM)
1 : Steady
Assign the destination of the call from the
Boss station which has Message Waiting
set.
•
(1)
(2)
Y=15
00-63: Tenant No.
X- XXXXXXXX: Secretary Station No.
CM90
CM20
CM08
START
END
CM13
CM51
,
,