FLASH OVER TRUNK
FLASH OVER TRUNK-D
term
– 258 –
A2247-10
FLASH OVER TRUNK
FLASH OVER TRUNK-D
term
PROGRAMMING
In addition to the programming of “DIRECT OUTWARD DIALLING”
page 227
, do the follow-
ing programming.
HARDWARE REQUIRED
D
term
and DLC card if required
DESCRIPTION DATA
Assign the dialing signal type (call origina-
tion) to the distant PBX to the route num-
ber assigned by CM30 Y=00.
•
(1)
(2)
Y=01
00-63: Trunk Route No.
2 : DP (10 PPS)
3 : DP (20 PPS)
4 : DTMF
7 : DTMF
Assign the data for the hooking signal
sending to outside to the route number as-
signed by CM30 Y=00.
•
(1)
(2)
Y=16
00-63: Trunk Route No.
1 : Sending
Assign the DTMF Signal Width, if the data
of CM35 Y=01 is 4 or 7, to the route num-
ber assigned by CM30 Y=00.
•
(1)
(2)
Y=26
00-63: Trunk Route No.
0 : 64 ms.
1 : 128 ms.
Specify the duration of hooking signal to
outside.
•
(1)
(2)
Y=2
17
02-30: 128 ms.-1920 ms.
(64 ms. increments)
If no data is set, the default setting is 576-
640 ms.
Assign the Switch Hook Flash key for
sending hooking signal to outside on a
D
term
, if required.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F1009
Assign the Flash Over Trunk key on the
ATTCON/DESKCON.
•
(1)
(2)
Y=00
ATTCON No. (E000-E007) + + Key
No.
F6106
CM41
START
CM35
END
CM90
,
,
To Next Page
Loading...
