NEC NEAX 2000 - Hot Line

HOT LINE
– 270 –
A2270-10
HOT LINE
PROGRAMMING
DESCRIPTION DATA
Assign the Hot Line to required stations. •
(1)
(2)
Y=03
X-XXXXXXXX: Station No.
04: Hot Line
Assign the Hot Line pair.
Bidirectional Hot Line should be assigned
as follows:
Hot Line P
air No. Calling Side Called Side
00 Station A Station B
01 Station B Station A
NOTE 1: Up to 100 Hot Line stations (50
pair) can be set.
•
(1)
(2)
(1)
(2)
Y=00-99 Hot Line Pair No.
0: Calling Side
X-XXXXXXXX: Station No./Data Sta-
tion No. assigned by
CM12 Y=03
1: Called Side
X-XXXXXXXX: Station No./Data Sta-
tion No.
E000-E007: Attendant Console No.
NOTE 2: Do not assign station number
with first digit “0”.
Specify the result of Switch Hook Flash on
Hot Line station.
To allow Hot Line stations to transfer a call
or access a feature, set the data to “0”.
(1)
(2)
057
0 : Special Dial Tone
1 : Attendant Recall
CM52
CM08
START
END
CM12