TENANT SERVICE
– 504 –
A2499-10
TENANT SERVICE
PROGRAMMING
DESCRIPTION DATA
Assign a Tenant number to each station. •
(1)
(2)
Y=04
X-XXXXXXXX: Station No.
00: Tenant No. 00
01 -63: Tenant No. 01-63
Assign a Tenant number to each trunk. •
(1)
(2)
Y=01
000-255: Trunk No.
00: Tenant No. 00
01 -63: Tenant No. 01-63
Assign a Numbering Plan Group number
to each Tenant.
(1)
(2)
00-63: Tenant No.
710-713: Numbering Plan Group 0-3
Assign required access codes for each
Numbering Plan Group.
To provide a trunk route for each Tenant,
assign Tenant Block 00-23 to desired
Trunk Route access code.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A000-A099
801-818
A100-A152
100-163
300-323: Tenant Block 00-23
When Tenant Block 00-23 is assigned by
CM20, assign a trunk route and Tenant
number to the Tenant Block.
•
(1)
(2)
Y=00-23 Tenant Block 00-23
00-63: Tenant No.
100-163: Trunk Route 00-63
When an External Key for Day/Night Mode
change or Class of Service change is re-
quired, assign the DK card to required
LEN.
NOTE: The DK card number must be as-
signed to the first LEN (level 0)
and the third LEN (Level 2).
(1)
(2)
000-763: LEN
E900-E963: DK Card No.
For PIM0/1: E900-E915
For PIM2/3: E916-E931
For PIM4/5: E932-E947
For PIM6/7: E948-E963
NOTE: Circuit No. 3 of E963 is used
for built-in External Key Inter-
face of MP card by setting
CM61.
CM30
CM29
CM20
CM12
CM23
CM10
A
START
To Next Page
Loading...
Need help?
General