UNIFORM CALL DISTRIBUTION (UCD)
– 546 –
A2546-10
UNIFORM CALL DISTRIBUTION (UCD)
PROGRAMMING
DESCRIPTION DATA
Specify the processing for an incoming
when all UCD Stations are busy.
(1)
(2)
212
0 : Busy Tone Connection
1 : Queuing
Specify the processing for a held call after
setting the UCD Busy Out.
(1)
(2)
214: For the held call from Tie Line
0 : Reconnected by Switch Hook
Flash
1 : Disconnected
(1)
(2)
215: For the held call from C.O. Line
0 : Reconnected by Switch Hook
Flash
1 : Disconnected
Specify the transferred C.O. call from a
station or an attendant is placed into queu-
ing mode when call UCD stations are
busy.
NOTE: This data is only effective when
CM08>212 is set to 1.
(1)
(2)
227
0 : This call is placed into queuing mode
NOTE
1 : Recall to the transferring station
when the call is transferred from
station, or Attendant Camp-On is
set when the call is transferred
from Attendant.
Enable the UCD Busy Out set and reset
from the secondary extension.
(1)
(2)
442
0 : Available
1 : Not available
START
CM08
A
To Next Page
Loading...
Need help?
General