HOTEL SYSTEM PROGRAMMING
Precaution/Station Number Data Loading
– 644 –
A2636-10
HOTEL SYSTEM PROGRAMMING
Precaution
Before programming the system data for the Hotel feature, confirm that the system is under the
following status.
• The system is under On-Line mode. (“RUN” lamp is flashing on the MP card.)
• The AP00 card is mounted in the correct location. (for SMDR with AP00, PMS, or Hotel
Printer)
• All the system data pertaining to the station, trunks, and service features have already been
programmed.
Station Number Data Loading
The AP00 stores the station number data loaded from the MP. When station numbers have been
added, deleted or changed by CM10, the station number data must be reloaded to the AP00 by
the following procedure.
(1) Flip the MB switch of the AP00 to UP position.
(2) Return the MB switch to DOWN position.
(3) The “**** AP00 START ****” message is printed if a printer provided.
(4) The “SORT COMPLETE” message is printed when the station number has been sent to the
AP00.
To Next Page
Loading...
