HOTEL SYSTEM PROGRAMMING
AP Initialization
– 645 –
A2636-10
AP Initialization
This section explains the data assignment to make the AP active. If the system have already
been applied the AP related feature, you can skip the data assignment explained on this section.
The AP should have already activated if one of the following feature was applied; SMDR (Station
Message Detail Recording), MCI (Message Center Interface), D
term
TIMS (Time Information
Management System), PMS (Property Management System), or Hotel Printer. You can distin-
guish whether the AP active or not by the RUN lamp indication. The RUN lamp flashes on green
color when the AP is in active.
When you install the AP00 for the first time, you should assign the data showing below.
DESCRIPTION DATA
Assign an AP number to the AP00 card.
The AP number must match the SENSE
switch setting on the AP00 card.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
04: AP00 card
On the AP00 card, set SW1 switch as
shown below.
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below:
NOTE
(1)
(2)
0000
CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
NOTE: After changing the SW1
switch as shown in the left,
MP reset is required.
START
CM05
END
CMD101
INITIAL
SW 1
ON
: POSITION TO BE SET
4
3
2
1
AP OFF LINE
SW1
ON
: POSITION TO BE SET
4
3
2
1
To Next Page
Loading...
