RELAY CONTROL FUNCTION KEY-D
term
– 403 –
A2397-10
RELAY CONTROL FUNCTION KEY-D
term
PROGRAMMING
HARDWARE REQUIRED
DK card or MP card (built-in DK)
External equipment provided locally
D
term
and DLC card
DESCRIPTION DATA
Assign the DK card to the required LEN.
NOTE 1: The DK Card number must be
assigned to the first LEN (Level
0) and the third LEN (Level 2) of
each LT.
(1)
(2)
000-763: LEN
E800-E831: DK Card No.
For PIM0/1: E800-E807
For PIM2/3: E808-E815
For PIM4/5: E816-E823
For PIM6/7: E824-E831
NOTE 2: Circuit No. 3 of E831 is used
for built-in External Equip-
ment Interface of MP card by
setting CM44.
Assign the function of relay control via
D
term
to the DK.
(1)
(2)
XX Y
XX : 00-31: DK Card No. assigned by
CM10
Y : 0-3: Circuit No.
313: MP Built-in External Equipment
Interface
1500: Relay Control (ON/OFF) Func-
tion Key via D
term
Assign the Relay Control (ON/OFF) key on
the required D
term
.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F7 XX Z
XX: 00-31: DK Card No. assigned by
CM44
Z : 0-3: Circuit No. assigned by CM44
CM44
CM90
START
END
CM10
,
To Next Page
Loading...
