NEC NEAX 2000 - Page 106

CALL FORWARDING-BUSY LINE
CALL FORWARDING-BUSY LINE-D
term
CALL FORWARDING-BUSY LINE-OUTSIDE
– 86 –
A2076-10
DESCRIPTION DATA
Assign Call Forwarding-Busy Line keys to
the D
term
, as required.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0014: Call Forwarding-Busy Line Set/
Cancel
For setting the same key as Call Forward-
ing-Don’t Answer
(2) F0012: Set/Cancel
To apply this feature to incoming call, set
up the combination of trunk routes for Tan-
dem Connection.
•
(1)
(2)
Y=05
00-63: Trunk Route No.
NOTE
1 : Release Signal arrives NOTE
NOTE:
For Resident System Program-
ming, refer to the Command
Manual.
•
(1)
(2)
Y=0
Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
0: Allow
Specify the setting method for Call For-
warding-Busy Line-Outside.
(1)
(2)
222
0 : The feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : The feature is set when receiving
Service Set Tone (ORT time out)
Provide Call Forwarding feature with each
tenant as per incoming call type.
•
•
•
(1)
(2)
Y=23 Internal Call or ATT assisted call
Y=24 C.O. Incoming Call
Y=25 Tie Line Incoming Call
00-63: Tenant No.
1 : Call Forwarding
CM08
CM90
A
CM35
CM65
CM36
B
,