NEC NEAX 2000 - Page 109

CALL FORWARDING-DON’T ANSWER
CALL FORWARDING-DON’T ANSWER-D
term
CALL FORWARDING-DON’T ANSWER-OUTSIDE
– 89 –
A2088-10
DESCRIPTION DATA
Assign Call Forwarding-Don’t Answer keys
to the D
term
, as required.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0016: Call Forwarding-Don’t Answer
Set/Cancel
For setting the same key as Call Forward-
ing-Busy Line
(2) F0012: Set/Cancel
Specify the timing for Call Forwarding-
Don’t Answer for a trunk incoming call.
•
(1)
(2)
Y=0
01
01-30: 4 sec.-120 sec.
(4 sec. increments)
If no data is set, the default setting is 32-36
sec.
Specify the timing for Call Forwarding-
Don’t Answer for an internal call or an as-
sisted call.
•
(1)
(2)
Y=0
15
01-30: 4 sec.-120 sec.
(4 sec. increments)
If no data is set, the default setting is 32-36
sec.
To apply this feature to incoming calls, as-
sign the combination of trunk routes for
Tandem connection.
•
(1)
(2)
Y=05
00-63: Trunk Route No.
NOTE
1 : Release Signal arrives NOTE
NOTE:
For Resident System Program-
ming, refer to the Command
Manual.
•
(1)
(2)
Y=0
Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
0: Allow
Specify the setting method for Call For-
warding-Don’t Answer-Outside.
(1)
(2)
222
0 : The feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : The feature is set when receiving
Service Set Tone (ORT time out)
CM35
CM08
CM90
A
CM36
CM41
B
,