NEC NEAX 2000 - Page 148

CALL INFORMATION SYSTEM (CIS)
PROGRAMMING
TIMS Printer Programming
– 128 –
A2107-10
DESCRIPTION
DATA
Assign a call development table number to
each outgoing trunk route.
(1)
(2)
00-63 : Trunk Route No.
0 -127: Type of call development table
No.
On the basis of each table number assigned by this command, the type of call to the dialed
digits is assigned by CMD034 as shown below.
Assign the type of call with respect to each
dialed digits (0-9, A, B) on the basis of
each call development table number as-
signed by CMD033.
(1)
(2)
XXX Y
XXX: 0-127: Call development table
No.
Y : 0-9, A (*), B (#): Dialed digit
NOTE: The actual digits sent from a
trunk should be assigned.
X1 : For assigning Type of Call
1 : Local Call
2 : Toll Call
3 : International Call
7 : Tie Line
8 : Tie Line
9 : Tie Line
XXX 0: For assign next digit develop-
ment table No.
XXX: 0-127: Next digit development ta-
ble No.
CMD033
J
CMD034
I
TRUNK ROUTE
ACCESS CODE
ROUTE XX
CMD033
0
1
2
9
Table
XX
Table
XX
0
1
2
TOLL
LOCAL TYPE OF
CALL
CMD034