NEC NEAX 2000 - Page 234

– 214 –
A2195-10
DIRECT DIGITAL INTERFACE (DDI)
PROGRAMMING
24-DTI Assignment
DESCRIPTION DATA
Assign a trunk route number for C.O.line
Interface to each DTI.
NOTE: The DTI route must be different
than any analog trunk route.
•
(1)
(2)
Y=00
000-255: Trunk No. assigned by CM07
Y=01
00-63: Trunk Route No.
Specify the terminating system in Day
Mode or Night Mode, Mode A, or Mode B
for incoming C.O. calls.
•
•
•
•
(1)
(2)
Y=02 Day Mode
Y=03 Night Mode
Y=40 Mode A
Y=41 Mode B
000-255: Trunk No. assigned by CM07
Y=01
02 : Trunk Line Appearance
03 : Trunk Line Appearance + TAS
04 : Direct-In Termination
08 : Dial-in
09 : Automated Attendant
10 : Attendant Console + TAS
11 : Attendant Console + Trunk Line
Appearance
12 : Attendant Console + Trunk Line
Appearance + TAS
14 : Termination to Attendant Console
16 : Remote Access to System
18 : ISDN Indial
31 : DID, Tie Line and any call which
is not handled by PBX
CM30
B
C