– 217 –
A2195-10
DIRECT DIGITAL INTERFACE (DDI)
PROGRAMMING
24-DTI Assignment
DESCRIPTION DATA
•
(1)
(2)
Y=3
10: Ground Start release (Loop off) de-
tect timing
01-15: 64 ms.-960 ms.
(64 ms. increments)
If no data is set, the default setting is 384
ms.
•
(1)
(2)
Y=3
11: Ground Start release (Ground off)
detect timing
01-15: 64 ms.-960 ms.
(64 ms. increments)
If no data is set, the default setting is 384
ms.
•
(1)
(2)
Y=3
12: Ground Start (Return Ground) de-
tect timing
01-15: 1 sec.-15 sec.
(1 sec. increments)
If no data is set, the default setting is 7 sec.
Assign an access code for the DTI trunk
route used as a C.O.line interface.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
100-163: Trunk Route No. 00-63
NOTE: The Least Cost Routing or Route Advance feature is also available for call origina-
tion via the DTI.
Refer to the following feature programming.
LEAST COST ROUTING-3/6 DIGIT
page 286
LEAST COST ROUTING-TIME OF DAY ROUTING
page 298
ROUTE ADVANCE
page 420
CM41
E
CM20
END
To Next Page
Loading...
