NEC NEAX 2000 - Page 285

FORCED ACCOUNT CODE
– 265 –
A2260-10
(2) With AP01 card
DESCRIPTION DATA
Assign the AP number to AP01 card.
NOTE: The AP number must match the
SENSE switch setting on the
AP01 card.
•
(1)
(2)
Y=0
04-15: AP No.
07: AP01
Designate the processor for Forced Ac-
count Code as AP01 card.
(1)
(2)
216
1 : AP (AP01 card)
Specify whether Service Set Tone is pro-
vided after dialing the access code for
Forced Account Code.
(1)
(2)
362
0 : No tone
1 : Service Set Tone
Assign the Service Restriction Class A for
Forced Account Code to required stations.
•
(1)
(2)
Y=02
X-XXXXXXXX: Station No.
XX ZZ
XX: 00-15 : Service Restriction Class
A
Allow Forced Account Code in the Service
Restriction Class A assigned by CM12
Y=02.
•
(1)
(2)
Y=31
00-15: Service Restriction Class A as-
signed by CM12 Y=02
1 : Allow
Set the ID Code and its temporary Service
Class used for Forced Account Code.
For the details of the programming, refer to
AUTHORIZATION CODE (with AP01
card).
page 52
•
•
•
•
Y=0
Y=1
Y=3
Y=A
Assign the access code for Forced Ac-
count Code.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A087
Specify the maximum number of digits for
Forced Account Code.
(1)
(2)
12
01-10: 1 digit-10 digits
NONE : 10 digits
If Check Code is provided, the maximum
number of digits is limit to 8.
START
CM05
CM15
CM08
CM12
CM42
CMD5
END
CM20
INITIAL