NEC NEAX 2000 - Page 426

REMOTE ACCESS TO SYSTEM
– 406 –
A2397-10
DESCRIPTION DATA
Assign terminating system in Day Mode,
Night Mode, Mode A and Mode B for in-
coming C.O. Calls to required trunks.
Specify the handling of busy/not available
Remote Access to System destination in
Day or Night Mode when calling an inter-
nal station.
•
•
•
•
(1)
(2)
•
•
(1)
(2)
Y=02 Day Mode
Y=03 Night Mode
Y=40 Mode A
Y=41 Mode B
000-255: Trunk No.
16: Remote Access to System
Y=30 Handling of busy/not available
Remote Access to System desti-
nation in Day Mode
Y=31 Handling of busy/not available
Remote Access to System desti-
nation in Night Mode
000-255: Trunk No.
00 : C.O. Line release
01 : Forwarded to TAS
03 : Forwarded to Attendant Console
04 : Forwarded to DIT station
assigned by CM30 Y=04, 05
06 : DT connection for redial
08 : C.O. line release
15 : C.O. line release
Assign the release signal condition to a in-
coming trunk route assigned by CM30
Y=00.
•
(1)
(2)
Y=05
00-63: Trunk Route No.
1 : Release signal arrives
Specify the combination of Trunk Routes
allowing the Trunk to Trunk Connection.
•
(1)
(2)
Y=0
XX ZZ
XX: 00-63: Incoming Trunk Route
ZZ: 00-63: Outgoing Trunk Route
0 : Allowed
1 : Restricted
Specify the maximum number of digits for
Remote Access to System.
(1)
(2)
13
01-16: 1 digit-16 digits
NONE : 16 digits
CM30
B
CM36
CM35
CM42
END