SINGLE DIGIT FEATURE ACCESS CODE
– 427 –
A2425-10
The associated access codes are preassigned as shown below, and cannot be changed.
On Busy Tone Connection On Ring Back Tone Connection
1. None 1. Voice Ring changeover
NOTE 4
2. Call Back/Outgoing Queuing NOTE 1, 2 2. Call Back-Don’t Answer NOTE 1, 2, 4
3. Executive Right of Way
NOTE 1, 2
3. None
4. Station Camp-On 4. None
5. Call Waiting 5. None
6. Message Reminder Set 6. Message Reminder Set
NOTE 4
7. Step Call (7 + Last one digit) NOTE 3 7. None
8. Message Record 8. Message Record
NOTE 4
9. None 9. None
NOTE 1: This feature cannot be set from Attendant Console.
NOTE 2: This feature cannot be set from a station having a held call.
NOTE 3: This feature can be set only from a station having a held incoming call.
NOTE 4: From a DTMF telephone, a hooking operation is required before dialing the single digit
access code.
This feature is mutually exclusive with Step Call.
However, 2 digit dialing Step Call can be provided by using this feature.
To Next Page
Loading...
