SOFT KEY-D
term
– 439 –
A2437-10
DESCRIPTION DATA
Assign the function of each Soft Key on
each status of the D
term
.
To the 2nd data of this command, the 2nd
data (F0XXX, F1XXX, F50XX) of CM90
should be assigned except for Scroll Key
data (F5002).
The LCD shows a maximum of 4 Soft Keys
at once. If assigning more than 4 Soft Keys
on one status, it is necessary to assign
Scroll Key at every 4 Keys (on 1st through
4th display).
NOTE 1: Scroll key must be assigned as a
key for each active display.
NOTE 2: Help key is only available in Pat-
tern No. 3.
NOTE 3: For the Pattern No. 3, the initial
Soft Key data for NEAX Mail AD-
8 live recording is assigned. See
the following section.
NOTE 4: Pattern No. 3 is fixed.
NOTE 5: For Dial By Name assignment,
refer to DIAL BY NAME-D
term
.
page 179
•
(1)
(2)
Y=00-03 Soft Key Pattern No. 0-3 as-
signed by CM12 Y=23
aa bb
aa: 00-15: Status No.
00: Idle state
01: During dialing (Holding no call)
02: During dialing (Holding station/
trunk)
03: During calling (Holding no call)
04: During calling (Holding station/
trunk)
05: Being called
06: When called party is busy
(Holding no call)
07: When called party is busy
(Holding station/trunk)
08: When called party sets DND
09: Trunk Busy
10: During Speaking (Holding no
call)
11: During Speaking (Holding sta-
tion/trunk)
12: During live recording/after live
recording to NEAX Mail AD-8
NOTE 3
13-15: Not used
bb: 00-15: Soft Key No.
00-03: Indicated on 1st display
04-07: Indicated on 2nd display
08-11: Indicated on 3rd display
12-15: Indicated on 4th display
F5002 : Scroll Key to change Soft Key
Indication
XXXXX: Setting of each function
(Same as “F0XXX, F1XXX,
F50XX” of CM90)
A
CM9A
B
To Next Page
Loading...
