NEC NEAX 2000 - Page 47

ANNOUNCEMENT SERVICE
– 27 –
A2018-10
NOTE: Announcement Service can be used to provide a voice message when an incoming
DID line/Tie line call has been terminated to a station and encounters a busy or no an-
swer condition. After the voice message is given, normal call processing continues.
•
This application can be programmed on a tenant basis.
• Only one (1) message of up to the following seconds can be recorded on an individ-
ual Digital Announcement Trunk Card.
Built-in DAT on MP: 120 sec.
4DAT card: 120 sec.
DESCRIPTION DATA
Assign the function of the Digital An-
nouncement Trunk card.
•
(1)
(2)
Y=00
000-001: Built-in DAT on MP card
002-127: Digital Announcement Trunk
Card No. (EB002-EB127) as-
signed by CM10
0D00: No Answer
0E00: Busy
Assign the Digital Announcement Trunk as
the destination of the DID call on each ten-
ant.
Assign the Digital Announcement Trunk as
the destination of the Tie Line call on each
tenant.
•
•
(1)
(2)
•
•
(1)
(2)
Y=00 No Answer
Y=03 Busy
00-63: Tenant No.
EB000-EB127: Digital Announcement
Trunk No.
Y=01 No Answer
Y=04 Busy
00-63: Tenant No.
EB000-EB127: Digital Announcement
Trunk No.
To record, replay and delete a message,
assign the Digital Announcement Trunk
access code respectively.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A100: Record
A101: Replay
A102: Delete
CM20
END
CM51
A
CM49