NEC NEAX 2000 - Page 528

TIE LINE ACCESS
– 508 –
A2499-10
DESCRIPTION DATA
•
(1)
(2)
Y=04
Answer Signal from distant office
00-63: Trunk Route No.
2 : Arrive
7 : No Signal
•
(1)
(2)
Y=05
Release Signal from distant office
00-63: Trunk Route No.
1 : Arrive
•
(1)
(2)
Y=08 Sending of Dial Pulse
00-63: Trunk Route No.
3 : Send
•
(1)
(2)
Y=09 Terminating System
00-63: Trunk Route No.
03: Wink Start
04: Delay Dial
05: Immediate Start
06: 2nd Dial Tone/Timing Start
•
(1)
(2)
Y=10 2nd DT sending on call termina-
tion
00-63: Trunk Route No.
0 : No Tone
1 : 2nd Dial Tone
•
(1)
(2)
Y=13 Maximum Number of Sending
Digits
00-63: Trunk Route No.
001-254: 1 digit-254 digits
If no data is set, sender is released when
timed out or called station answer.
Assign the appropriate data for the char-
acteristic of distant PBX.
NOTE: This data should be set to each
route according to the data for
CM35 Y=09, as shown below.
Data f
or CM35 Y=09 Data for CM35 Y=20
03 00
04 01
05 15
06 15
•
(1)
(2)
Y=20 Sender Start Condition
00-63: Trunk Route No.
00 : Wink Start
01 : Delay Dial
15 : Timing Start
(Prepause per CM35 Y=21)
CM35
A
B