NEC NEAX 2000 - Page 580

UNIFORM NUMBERING PLAN
– 560 –
A2556-10
Example 2: When the PBX is a Tandem Office in the network.
Programming for Example 2:
COMMAND CODE 1ST DATA 2ND DATA REMARKS
20 Y=0 8 A126 Assignment of Access Code 8 of LCR Group 0.
8A Y=A000 0 4005 Assignment of Area Code
Development Pattern No. 5.
8A Y=4005 21 0001 Assignment of Route Pattern
No. 001 to the Area Code 21 of Office B.
8A Y=4005 838 8000 Assignment of Intra-Office
Termination to the office code 838.
8A Y=0000 1 00001 Assignment of the order of LCR selection (1st)
for Route Pattern No. assigned by CM8A
Y=4005.
PBX
OFFICE
A
OFFICE
B
838-XXXX
821-XXXX
DIAL NO.
821-XXXX
/8838-XXX
TRUNK ROUTE 01
Trunk Route to Office B:
Tie Line Access Code:
Area Code of Office:
Intra-Office Termination:
XXX
21-XXXX
/838-XXX
XXXX
838 (PBX)
01
8
21