NEC NEAX 2000 - Page 594

VOICE MAIL INTEGRATION
– 574 –
A2566-10
DESCRIPTION DATA
Assign the access code for MW lamp set/
cancel from a VMS station port.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A040: Set
A041: Reset
Assign the access code to retrieve a mes-
sage from the VMS and search Message
Reminder/Message Waiting.
•
(1)
(2)
Y=0-3 Numbering Plan Group0-3
X-XXXX: Access Code
A146: Search
A147: Retrieve
Assign the access code to be sent out to a
VMS after/before a Mail Box number, if re-
quired.
NOTE 1: “C” or “D” should not be assigned
as the first digit of an access
code, to insert prepause timing.
Prepause timing is assigned by
CM41 Y=0>44.
NOTE 2: If “C” is inserted in the access
code, it can be used as a pause
(1.5 sec.). To provide a program-
mable pause, insert “D” instead
of “C” (Programmable Pause:
CM41 Y=0>38).
•
(1)
(2)
Y=00
3: Access Code to be sent out before a
Mail Box No.
NOTE 1
4: Access Code to be sent out after a
Mail Box No.
XX-XXXX: Access code to be sent out
to a VMS
X: 0-9, A (*), B (#), C/
D (Pause)
NOTE 2
NONE : Not sent out
Specify the prepause timing, PB signal
width, and Inter-digital pause for VMS.
•
(1)
(2)
Y=0
44: Prepause Timing
00-12: 0 sec.-12 sec.
(1 sec. increments)
13 : 0.5 sec.
If no data is set, the default setting is 1 sec.
Specify the PB signal width for VMS. •
(1)
(2)
Y=0
48
01: 64 ms.
02: 128 ms.
If no data is set, the default setting is 128
ms.
CM41
CM20
A
B
CM50