NEC NEAX 2000 - Page 77

AUTOMATED ATTENDANT
– 57 –
A2056-10
DESCRIPTION DATA
•
(1)
(2)
Y=33 Handling of all PBR busy when
Y=30, 31 is set to 08
000-255: Trunk No.
00 : C.O. line release
01 : Forwarded to TAS indicator
03 : Forwarded to Attendant Console
15 : C.O. line release
Assign the PB (DTMF) Receiver for only
Automated Attendant, if desired.
•
(1)
(2)
Y=2
XX Z: DTMF Receiver No.
XX: 00: Built-in PBR on MP card
01-15: 8RST Card No. E200-E215
assigned by CM10
Z : 0-3: Circuit No.
0: Only for Automated Attendant
Specify whether inter-tenant connection is
allowed on an Automated Attendant in-
coming call.
•
(1)
(2)
Y=2
XX ZZ
XX: 00-63: Tenant No. of called station
ZZ: 00-63: Tenant No. of trunk
0 : Restricted
1 : Allowed
Assign the answering method for the Auto-
mated Attendant, to the required tenants.
•
(1)
(2)
Y=0
00-63: Tenant No.
00 : DT connection
01 : Hold Tone on MP card and DT
connection
02 : 1st Answering Message and DT
connection
03 : DT connection
For providing a Night Message, assign the
answering method of Night Mode, to the
required tenants.
•
(1)
(2)
Y=2
00-63: Tenant No.
00 : DT connection
01 : Hold Tone on MP card and DT
connection
02 : Night Message assigned by
CM49 Y=00>02XX
03 : According to the data set by
CM64 Y=0
CM30
A
B
CM45
CM63
CM64