Newport XPS-D Programmer's Manual

XPS Unified Programmer’s Manual
6.5.4 ZYGO Error Code Table
Error Code
Description
-100001
Syntax error in command or unrecognized command
-100002
Internal error occurred while parsing request
-100003
Invalid character detected in command input
-100004
Un-terminated string
-100005
Invalid hex number
-100020
Error accessing the Measuring Board
-100021
Operation not supported for ZEC-Measuring Board set
-100022
Invalid Register offset detected
-100023
Invalid axis number detected
-100024
Invalid ADC Mux value detected
-100025
ADC operation timed out
-100026
Invalid EEPROM offset detected
-100027
EEPROM operation timed out
-100028
Invalid register type specified
-100029
Value to write too large for register type
-100030
Value to write missing
-100031
Invalid operation type specified
-100032
Value to write invalid
-100033
Internal error saving Ethernet Card configuration data
-100034
Invalid IP address
-100035
Invalid Subnet mask
-100036
Invalid Gateway IP address
-100037
UDP Measurement Data transmission already in progress
-100050
Another Firmware update is already in progress
-100051
Firmware update irrecoverable file transfer error
-100052
Firmware update file data received is incomplete
-100053
Firmware update error performing a PROM operation
The error description is returned by the “ErrorStringGet” function.
All error code list is returned by the “ErrorListGet” function.
39 EDH0373En1023 — 01/18

Newport XPS-D Specifications

General

Brand	Newport
Model	XPS-D
Category	Controller
Language	English