Newport XPS-D - Zygointerferometerstatusget

XPS Unified Programmer’s Manual
7.2.2.50 ZygoInterferometerStatusGet
Name
ZygoInterferometerStatusGet – Gets ZYGO interferometer status.
Input tests
- Refer to section 7.1: “Input Tests Common to all XPS Functions”.
Description
Get ZYGO interferometer status:
- Ethernet connection status.
- Axis #1 signal status.
- Axis #2 signal status.
- Reference signal status.
- P2 Board status.
Prototype
int ZygoInterferometerStatusGet(
int SocketID,
int * EthernetCommunicationStatus,
int * ZygoAxis1MeasureSignal,
int * ZygoAxis2MeasureSignal,
int * ZygoReferenceSignalStatus,
int * ZygoP2BoardStatus
)
Input parameters
SocketID int Socket identifier gets by the
“TCP_ConnectToServer” function.
Output parameters
EthernetCommunicationStatus int * 1 = Connected, 0 = Not connected.
ZygoAxis1MeasureSignal int * 1 = Axis #1 signal present, 0 = No signal.
ZygoAxis2MeasureSignal int * 1 = Axis #2 signal present, 0 = No signal.
ZygoReferenceSignalStatus int * 1 = Reference signal present, 0 = No Signal.
ZygoP2BoardStatus int * 1 = P2 board ready, 0 = P2 board not ready or
not present.
Return (In addition to the results of “Input Tests Common to all XPS
Functions”)
• 0: No error.
EDH0373En1023 — 01/18 648