XPS Unified Programmer’s Manual
Return (In addition to the results of “Input Tests Common to all XPS
Functions”)
• 0: No error.
• -17: Parameter out of range or incorrect.
• -22: Not allowed action.
• -25: Following Error.
• -26: Kill command or Emergency signal: check each positioners and each
slave positioners, check that motion does not exceed software limits
when combined with mapping and other features.
• -27: Move Aborted.
• -28: Home search timeout.
• -33: Motion done timeout.
• -35: Position is outside of travel limits.
• -44: Slave error disabling master.
• -49: Inconsistent mechanical zero during home search.
• -50: Motor initialization error. Check InitializationAccelerationLevel,
ScalingAcceleration, MaximumJerkTime, EncoderResolution or
EncoderScalePitch.
• -113: Both ends of run activated.
• -120: Warning following error during move with position compare enabled.
• -200: Invalid socket.
• -205: Not enable in your configuration.
EDH0373En1023 — 01/18 610
To Next Page
Loading...
Need help?
General
