Oce PRISMAproduction - Page 124

Vario PJM PRISMAproduction Explorer
112 A29247-X3-X-6-7670
’Print on front cover
sheet’
Available options:
- None
- Print on Side 1
- Print on Side 2
- Print on Both Sides
’Paperformat’ Select a paper, which has been defined in the PRISMAproduction database via
’Configuration’ -> ’Paper’ for the front page.
’Print on back cover
sheet’
Available options:
- None
- Print on Side 1
- Print on Side 2
- Print on Both Sides
’Paperformat’ Select a paper, which has been defined in the PRISMAproduction database via
’Configuration’ -> ’Paper’ for the back page.
Note: If you define cover pages, which have already been defined as special pages, the correspon-
ding entry for the special pages is adjusted (i.e. the first and last valid page is inserted). and a mes-
sage is issued.
Blank Sheets (only with ’Standard’, ’Stiched’ and ’2 identical copies’)
’Display area’ Lists all blank pages which you insert with the ’Add’ button below the list. Single
entries in the list can be marked for deletion or modification.
’Before Page’ Define the page number before which one or more blank pages should be in-
serted. See notes after this table!
’Number’ Define the number of blank pages to be inserted.
’Input Tray’ Select the physical tray. Depends on the selected printer.
’Paperformat’ Select a paper, which has been defined in the PRISMAproduction database via
’Configuration’ -> ’Paper’ for the front page.
’Add’ All parameters defined are added to the list above. The list is sorted by the
page number.
’Change’ Modify the parameters of a marked entry in the list.
’Delete’ Marked entries are deleted from the list.
Notes: As you cannot define blank pages as cover pages, these will be ignored when submitting the
job and a message is issued.
When inserting blank pages, note the following:
If you insert pages between the front- and backpage of a duplex page, the backpage becomes the
frontpage of the following sheet. This means, all subsequent duplex pages will be moved one page
backwards until the next simplex page or until the end of the job (except for the cover sheet).
Tab Printing (only with ’Standard’)
’Tab Set’ Displays the tab set used for tab printing.
’Position Modus’ Displays the position mode selected.
’Positions’ Displays the positions on which the tabs are to be inserted. Only possible if ’Po-
sition Modus’=’List from Ticket’.
’Resource’ Displays the resource for the tab set. Only possible if ’Position Modus’=’List
from Ticket’.