Configuration LP
A29247-X6-X-6-7670 205
Options:
-P[printer name] The logical printer name as descriptor in the printcap file.
This parameter is required
[jobid] To find a specific jobid, the command "lpq" can be used.
If the only the user name is given (e.g. "admin"), then all-
jobs of this user are deleted.
Examples:
lprm PPS700 00001123
This command cancels the job "00001123" which was submitted for logical printer PS700.
lprm PPS700 admin
This command cancels all jobs which have been submitted by the user "admin" for logical
printer PS700.
6.19.5 Control Function ”lpc”
Syntax: lpc [sub-command]
Description:
The lpc (line printer control) command is mostly for administration tasks and therefore some
of the subcommands may only be executed by the super user. If the user is not authorized,
the command will be ignored and the error message "->Privileged command" will be dis-
played instead.
The control function can either be invoked in interactive mode by simply typing "lpc" at the
command line, or together with a sub-command and the required options. In interactive
mode, it is possible to enter sub-commands along with the required options. It is stopped
with the command "quit" or "exit".
Sub-commands:
abort {all | [printer ...]} Terminate the spooling daemon immediately
for all or the specified printer
clean {all | [printer ...]} Clean up the spool directory for all or the spec-
ified printer
disable {all | [printer ...]} Disable queuing for all or the specified printer
enable {all | [printer ...]} Enable queuing for all or the specified printer
To Next Page
Loading...
