Oce PRISMAproduction - Printer Administrator

Printer Administrator Command Line Interface
310 A29247-X2-X-8-7670
9.3 Printer Administrator
The printer administrator is started with the following command:
spladmin [{Option} {Function} {Operand}]
Entering the command without a function or operand displays general information on the
spladmin command:
Command: spladmin -s spool
Enables or disables the spool services on the current system.
'spladmin -s'
'spool' Display spool status
' ... on' Enable spool
' ... off' Disable spool
'spladmin -p' Display printer status for all printers
'spladmin -p NAME ...' Commands relating printer 'NAME' only
'... printer' on | off | halt | reset | cancel,del[cp][jb]
cancel,hold[cp][jb] | cancel,int[cp][jb]
'... jobcl' {Queue} [add|rem] (Queue: 0-999)
'... npro' {NPRO value} (NPRO value: 0-12h)
'... form' {Form-Id}
'... automode' on | off
'... checkform' on | off | on,seq
'... checkres' on | off
'... checkprn' on | off
'... checkcls' on | off
'spladmin -s'
'spool' Display spool status
' on' Enable spool
' off' Disable spool
'protocol' Display protocol level
' off' Disable protocol.
' X' Set trace level to X