Master/Slave Configuration
160 A29247-X6-X-6-7670
6.8 Master/Slave
Select ’Configuration’ -> ’Master/Slave’ to configure the PRISMAproduction computers in
an PRISMAproduction network by entering their IP addresses. All the other details in the
Master/Slave table are provided by the system. The entry for the master is also provided by
the system.
Before adding a server you have to check the following:
• The IP address of the first network card is the address, which is used by PRISMApro-
duction (check this with /sbin/ifconfig, entry under eth0). This address must
be accesible in the PRISMAproduction network.
• Job acception and job processing must be switched off.
• The etc/hosts file of all servers (Master and Slaves) must contain all servers of the
PRISMAproduction network. Please take care for the correct syntax:
Example: 160.120.20.111 charly.ops.de charly
Column Titles
’Server’ menu and toolbar see ’Editing configuration data’ on page 138.
IP-Address The IP address of the server. If you want to
Name The symbolic name of the server
Type The type of computer: master, client or PrintSlave
OP-System The server operating system.
To Next Page
Loading...
