PRISMAproduction Explorer PJM
A29247-X3-X-6-7670 115
5.12 PJM
see chapter ’Print Job Manager’.
’Image Shift X Back’ Insert an image shift in x direction on the back page (from -500 to 500 mm or
from -19,68 to 19,68 inch). This is only possible with jobtype ’Standard’.
As measure units you can use ’mm’, ’cm’, ’pixel’ or ’inch’.
’Image Y Shift Back’ Insert an image shift in y direction on the back page (from -500 to 500 mm or
from -19,68 to 19,68 inch). This is only possible with jobtype ’Standard’.
As measure units you can use ’mm’, ’cm’, ’pixel’ or ’inch’.
’Layout’ Define the layout for the print job. Depending on the jobtype you have the fol-
lowing possibilities:
- Simplex
- Duplex
- Tumble
’Input Tray’ Select the physical tray. Depends on the selected printer.
The textfield underneath displays the paper, which is inserted in the input tray
chosen.
’Add’ All parameters defined are added to the list above. The list is sorted by the
page number.
’Change’ Modify the parameters of a marked entry in the list.
’Delete’ Marked entries are deleted from the list.
Notes: As you cannot define special pages as cover sheets with printing, a corresponding
entry will be adjusted (i.e. the first or last valid page is entered). A message is displayed
accordingly.
Special pages shifts apply always to the pages specified, also if no material is changed or
material is moved.
Not the following, if special pages cause a change of the print data and/or a change of ma-
terial:
If the frontpage of a duplex page is defined as special page only, the backpage becomes
the frontpage of the following sheet. This means, all subsequent duplex pages will be
moved one page backwards until the next simplex page or until the end of the job (except
for the cover sheet).
To Next Page
Loading...
