Panasonic FP0R - Table of MEWTOCOL-COM Communication Error

15-78
15.4.3 Table of MEWTOCOL-COM Communication Error
Error
code
Name Description
!21
NACK error
Link system error
!22
WACK error
Link system error
!23
Unit No. overlap
Link system error
!24
Transmission format
error
Link system error
!25
Link unit hardware
error
Link system error
!26 Unit No. setting error Link system error
!27
No support error
Link system error
!28
No response error
Link system error
!29
Buffer closed error
Link system error
!30
Time-out error
Link system error
!32
Transmission
impossible error
Link system error
!33
Communication stop
Link system error
!36
No destination error
Link system error
!38
Other communication
error
Link system error
!40
BCC error
A transfer error occurred in the received data.
!41
Format error
A command was received that does not fit the format.
!42
No support error
A command was received that is not supported.
!43
Multiple frames
procedure error
A different command was received when processing multiple
frames.
!50 Link setting error
A route number that does not exist was specified. Verify the route
number by designating the transmission station.
!51
Transmission
time-out error
Transmission to another device not possible because transmission
buffer is congested.
!52
Transmit disable
error
Transmission processing to another device is not possible.(Link
unit runaway, etc.)
!53 Busy error
Command process cannot be received because of multiple frame
processing. Or, cannot be received because command being
processed is congested.
!60
Parameter error
Content of specified parameter does not exist or cannot be used.
!61 Data error
There was a mistake in the contact, data area, data number
designation, size designation, range, or format designation.
!62
Registration over
error
Operation was does when number of registrations was exceeded
or when there was no registration.
!63 PC mode error
PC command that cannot be processed was executed during RUN
mode.