Quantum Scalar 1000

Scalar DLC Reference Guide 167
For the details of the SCSI command format, refer to:
• SCSI Reference Manual for the Scalar 10K library.
• SCSI Reference Manual for the Scalar 1000 library.
The Target can operate either in SCSI-2 or in SCSI-3 mode. All the LUNs of this target will work in this mode
as well, and this will be the standard for all clients assigned to these LUNs. For the details of the SCSI Mode
refer to:
• SCSI Primary Commands 2 (SPC-2) Manual
• SCSI Primary Commands 3 (SPC-3) Manual
Note
The newly created target already contains LUN 0. If the other LUNs are required, they
should be created manually.
CAUTION
When the SCSI Target is removed, all SCSI Clients configured for LUNs of this
target are removed as well.
Note
Because of interface properties, one and only one SCSI Client can be assigned to the
single LUN.
CAUTION
After the client is assigned to the LUN 0 of any target, all other clients
assigned to the non-zero LUNs of this target are activated.