278 ROBAR Guide
Example1 (for DOS or Windows-based system):
C:>\ Set PORT = 1010
C:>\ Set HOST = computer
Example2 (for Unix-like systems):
#PORT = 1010 export PORT
#HOST = computer export HOST
Step 6 If the customer uses HCC/MVS, this also must be configured in the ROBAR client settings.
Refer to ROBAR Client
on page 158.
Now, the Scalar DLC software is ready to accept commands from ROBAR Client.
ROBAR Commands
Table 41 ROBAR Commands
Command Description
ACOM Checks the communication to the Scalar DLC software and get information
about the library status.
AOFF Programs end of the Scalar DLC software.
AUTO Switches from manual or test mode to the automatic mode.
BOF Switches the barcode reading for the sending host off.
BON Switches the barcode reading for the sending host on.
CLM Clean manager status and configuration command.
CLU Closes the flap on a drive.
DL Changes a archive catalog entry.
EJ Ejects data cartridges - temporary.
EJT Ejects data cartridges - complete.
EJTC Ejects complete - used cleaning cartridges.
FLIP Toggles the side of a Optical Disk in an Optical Disk drive.
IN Inserts data cartridges by a logical range.
INC Verifies the archive with the database by a given coordinate.
INSC Inserts clean cartridges by a logical range.
INV Inventory of a given volser.
IVK Inventory of a given coordinate range.
IVV Inventory of a given volser.
KE Moves a cartridge from drive to the home position.
To Next Page
Loading...
Need help?
General