R&S FSV3000 Series - Page 1106

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1106User Manual 1178.8520.02 ─ 01
[SENSe:]CORRection:FRESponse:BASeband:USER:FLISt<fli>:PHASe[:STATe]
<State>
[SENSe:]CORRection:FRESponse:INPut<ip>:USER:FLISt<fli>:PHASe[:STATe]
<State>
[SENSe:]CORRection:FRESponse:USER:FLISt<fli>:PHASe[:STATe] <State>
Activates or deactivates the use of the correction data in the selected file for magnitude
results.
Suffix:
<fli>
.
1..n
Index in frequency response file list
Use [SENSe:]CORRection:FRESponse:BASeband:USER:
FLISt<fli>:SIZE? to determine the maximum index number.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Applies the data for magnitude results.
ON | 1
Does not apply the data for magnitude results.
*RST: 1
Example:
SENS:CORR:FRES:USER:FLIS2:PHAS:STAT ON
Manual operation: See "Phase" on page 611
[SENSe:]CORRection:FRESponse:BASeband:USER:FLISt<fi>:REMove
[SENSe:]CORRection:FRESponse:INPut<ip>:USER:FLISt<fli>:REMove
[SENSe:]CORRection:FRESponse:USER:FLISt<fli>:REMove
Removes the selected frequency response (.fres) file from the current configuration.
Suffix:
<fli>
.
1..n
Index in frequency response file list
Use [SENSe:]CORRection:FRESponse:BASeband:USER:
FLISt<fli>:SIZE? to determine the maximum index number.
Example:
SENS:CORR:FRES:USER:FLIS2:REM
Usage: Event
Manual operation: See "Remove Frequency Response File" on page 611
[SENSe:]CORRection:FRESponse:BASeband:USER:FLISt<fli>:SELect <FilePath>
[SENSe:]CORRection:FRESponse:INPut<ip>:USER:FLISt<fli>:SELect <FilePath>
[SENSe:]CORRection:FRESponse:USER:FLISt<fli>:SELect <FilePath>
Loads an additional frequency response (.fres) file to the current configuration.
Configuring the R&S
FSV/A