R&S FSV3000 Series - Page 447

Common Analysis and Display Functions
R&S
®
FSVA3000/ R&S
®
FSV3000
447User Manual 1178.8520.02 ─ 01
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:RESult? on page 1016
Marker State ...............................................................................................................447
Marker Type ............................................................................................................... 447
Noise Measurement State ..........................................................................................447
Switching All Noise Measurement Off ........................................................................447
Marker State
Activates or deactivates the marker in the diagram.
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 987
CALCulate<n>:DELTamarker<m>[:STATe] on page 985
Marker Type
Toggles the marker type.
The type for marker 1 is always "Normal" , the type for delta marker 1 is always
"Delta" . These types cannot be changed.
Note: If normal marker 1 is the active marker, switching the "Mkr Type" activates an
additional delta marker 1. For any other marker, switching the marker type does not
activate an additional marker, it only switches the type of the selected marker.
"Normal"
A normal marker indicates the absolute value at the defined position
in the diagram.
"Delta"
A delta marker defines the value of the marker relative to the speci-
fied reference marker (marker 1 by default).
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 987
CALCulate<n>:DELTamarker<m>[:STATe] on page 985
Noise Measurement State
Activates or deactivates noise measurement for the marker in the diagram.
This function is only available for normal markers.
If activated, the marker displays the noise power density measured at the position of
the marker.
For details see Chapter 9.3.4.2, "Measuring Noise Density (Noise Meas Marker)",
on page 445.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:NOISe[:STATe] on page 1016
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:RESult? on page 1016
Switching All Noise Measurement Off
Deactivates noise measurement for all markers.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:NOISe[:STATe] on page 1016
Marker Usage