R&S FSV3000 Series - Page 769

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
769User Manual 1178.8520.02 ─ 01
Suffix:
<sb>
.
1..n
sub block number
<ch> 1..n
Tx channel number
Parameters:
<Bandwidth> Bandwidth in Hz
Default unit: Hz
Manual operation: See " Tx Channel Bandwidth " on page 174
[SENSe:]POWer:ACHannel:SBLock<sb>:CENTer[:CHANnel<ch>]
<Frequency>
This command defines the (absolute) center frequency of the specified MSR Tx chan-
nel.
Note that the position of the first Tx channel in the first sub block and the last Tx chan-
nel in the last sub block also affect the position of the adjacent channels.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer<sb>:PRESet on page 752).
Suffix:
<sb>
.
1..n
sub block number
<ch> 1..n
Tx channel number
Parameters:
<Frequency> absolute frequency in Hz
Default unit: Hz
Manual operation: See " Tx Center Frequency " on page 174
[SENSe:]POWer:ACHannel:SBLock<sb>:FREQuency:CENTer <Frequency>
This command defines the center of the specified MSR sub block. Note that the posi-
tion of the sub block also affects the position of the adjacent gap (CACLR) channels.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer<sb>:PRESet on page 752).
Suffix:
<sb>
.
1..n
sub block number
Parameters:
<Frequency> absolute frequency in Hz
Default unit: Hz
Manual operation: See " Sub Block / Center Freq " on page 173
Configuring and Performing Measurements