R&S FSV3000 Series - Page 780

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
780User Manual 1178.8520.02 ─ 01
Manual operation: See " Gap Channel Spacing " on page 179
MSR Channel Names
The functions for manual operation are described in Chapter 7.3.5.5, "MSR Channel
Names", on page 180.
[SENSe:]POWer:ACHannel:NAME:GAP<gap>..................................................................780
[SENSe:]POWer:ACHannel:NAME:UACHannel................................................................ 780
[SENSe:]POWer:ACHannel:NAME:UALTernate<ch>......................................................... 780
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>]........................................780
[SENSe:]POWer:ACHannel:NAME:GAP<gap> <Name>
This command defines a name for the GAP channel.
Suffix:
<gap>
.
1..n
Gap channel number
Parameters:
<Name> String containing the name of the channel
*RST: Gap1, Gap2
[SENSe:]POWer:ACHannel:NAME:UACHannel <Name>
This command defines the name for the upper adjacent channel in asymmetrical MSR
channel definitions. To define the name for the lower adjacent channel use the
[SENSe:]POWer:ACHannel:NAME:ACHannel command.
Parameters:
<Name> String containing the name of the channel
*RST: ADJ
[SENSe:]POWer:ACHannel:NAME:UALTernate<ch> <Name>
This command defines the name for the specified upper alternate channel in asymmet-
rical MSR channel definitions. To define the name for the lower adjacent channels use
the [SENSe:]POWer:ACHannel:NAME:ALTernate<ch> command.
Suffix:
<ch>
.
1..n
Alternate channel number
Parameters:
<Name> String containing the name of the channel
*RST: ALT<1...11>
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>] <Name>
This command defines the name of the specified MSR Tx channel.
Configuring and Performing Measurements