R&S FSV3000 Series - Page 792

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
792User Manual 1178.8520.02 ─ 01
CALCulate<n>:LIMit<li>:ESPectrum<sb>:RESTore............................................................792
[SENSe:]ESPectrum<sb>:PRESet[:STANdard]................................................................. 792
[SENSe:]ESPectrum<sb>:PRESet:RESTore..................................................................... 792
[SENSe:]ESPectrum<sb>:PRESet:STORe....................................................................... 793
CALCulate<n>:LIMit<li>:ESPectrum<sb>:RESTore
This command restores the predefined limit lines for the selected Spectrum Emission
Mask standard.
All modifications made to the predefined limit lines are lost and the factory-set values
are restored.
Suffix:
<n>
.
irrelevant
<li> irrelevant
<sb> irrelevant
Example:
CALC:LIM:ESP:REST
Resets the limit lines for the current Spectrum Emission Mask
standard to the default setting.
[SENSe:]ESPectrum<sb>:PRESet[:STANdard] <Standard>
This command loads a measurement configuration.
Standard definitions are stored in an xml file. The default directory for SEM standards
is C:\R_S\INSTR\\sem_std.
Suffix:
<sb>
.
1..n
Sub block in a Multi-SEM measurement
Parameters:
<Standard> String containing the file name.
If you have stored the file in a subdirectory of the directory men-
tioned above, you have to include the relative path to the file.
Manual operation: See " Standard / MSR Settings " on page 228
See " Load Standard " on page 235
[SENSe:]ESPectrum<sb>:PRESet:RESTore
This command restores the default configurations of predefined SEM standards.
Note that the command will overwrite customized standards that have the same name
as predefined standards.
Suffix:
<sb>
.
1..n
Sub block in a Multi-SEM measurement
Manual operation: See " Restore Standard Files " on page 236
Configuring and Performing Measurements