EasyManua.ls Logo

R&S FSV3000 Series - Page 797

R&S FSV3000 Series
1268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
797User Manual 1178.8520.02 ─ 01
[SENSe:]ESPectrum<sb>:RANGe<ri>:COUNt?
This command queries the number of ranges in the sweep list.
Suffix:
<sb>
.
<ri> irrelevant
Return values:
<Ranges> Number of ranges in the sweep list.
Usage: Query only
[SENSe:]ESPectrum<sb>:RANGe<ri>:DELete
This command removes a range from the sweep list.
Note that
you cannot delete the reference range
a minimum of three ranges is mandatory.
Suffix:
<sb>
.
<ri> Selects the measurement range.
Manual operation: See " Delete Range " on page 226
[SENSe:]ESPectrum<sb>:RANGe<ri>:FILTer:TYPE <FilterType>
This command selects the filter type for an SEM range.
In case of high speed measurements, the filter has to be identical for all ranges.
Suffix:
<sb>
.
1 | 2 | 3
<ri> 1...30
Selects the measurement range.
Manual operation: See " Filter Type " on page 223
[SENSe:]LIST:RANGe<ri>[:FREQuency]:STARt <Frequency>
This command defines the start frequency of a spurious emission measurement range.
Make sure to set an appropriate span. If you set a span that is
smaller than the span the sweep list covers, the R&S FSV/A will not measure the
ranges that are outside the span - results may be invalid.
greater than the span the sweep list covers, the R&S FSV/A will adjust the start fre-
quency of the first range and the stop frequency of the last range to the span
Configuring and Performing Measurements

Table of Contents

Other manuals for R&S FSV3000 Series

Related product manuals