R&S FSV3000 Series - Page 829

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
829User Manual 1178.8520.02 ─ 01
POSitive
peak detector
SAMPle
sample detector
RMS
RMS detector
AVERage
average detector
*RST: RMS
Manual operation: See " Detector " on page 257
[SENSe:]LIST:RANGe<ri>:FILTer:TYPE <FilterType>
This command selects the filter type for a spurious emission measurement range.
Suffix:
<ri>
.
1..30
Selects the measurement range.
Manual operation: See " Filter Type " on page 257
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation <Attenuation>
This command defines the input attenuation for a spurious emission measurement
range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<Attenuation> Numeric value.
Refer to the data sheet for the attenuation range.
*RST: 10 dB
Default unit: dB
Manual operation: See " RF Attenuation " on page 258
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation:AUTO <State>
This command turns automatic selection of the input attenuation for a spurious emis-
sion measurement range on and off.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Configuring and Performing Measurements