EasyManua.ls Logo

R&S FSV3000 Series - Page 831

R&S FSV3000 Series
1268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
831User Manual 1178.8520.02 ─ 01
[SENSe:]LIST:RANGe<ri>:LIMit:STOP <Level>
This command defines an absolute limit for a spurious emission measurement range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<Level> Absolute limit at the stop frequency of a SEM range.
Range: -400 to 400
*RST: 13
Default unit: dBm
Manual operation: See " Abs Limit Start / Abs Limit Stop " on page 259
[SENSe:]LIST:RANGe<ri>:POINts[:VALue] <Points>
This command defines the number of sweep points in a spurious emission measure-
ment range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<Points> For more information on sweep points see Chapter 8.5.1.8,
"How Much Data is Measured: Sweep Points and Sweep
Count", on page 381.
*RST: 1001
Manual operation: See "Sweep Points" on page 258
[SENSe:]LIST:RANGe<ri>:RLEVel <RefLevel>
This command defines the reference level for a spurious emission measurement
range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<RefLevel> Reference level.
Refer to the data sheet for the reference level range.
*RST: 0 dBm
Default unit: dBm
Manual operation: See " Reference Level " on page 258
[SENSe:]LIST:RANGe<ri>:SWEep:TIME <SweepTime>
This command defines the sweep time for a spurious emission measurement range.
Configuring and Performing Measurements

Table of Contents

Other manuals for R&S FSV3000 Series

Related product manuals