EasyManua.ls Logo

R&S FSV3000 Series - Page 832

R&S FSV3000 Series
1268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
832User Manual 1178.8520.02 ─ 01
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<SweepTime> Sweep time.
The range depends on the ratios of the span to the RBW and
the RBW to the VBW. Refer to the data sheet for more informa-
tion.
Manual operation: See " Sweep Time " on page 257
[SENSe:]LIST:RANGe<ri>:SWEep:TIME:AUTO
<State>
This command turns automatic selection of the sweep time for a spurious emission
measurement range on and off.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Manual operation: See " Sweep Time Mode " on page 257
[SENSe:]LIST:RANGe<ri>:TRANsducer <Transducer>
This command selects a transducer factor for a spurious emission measurement
range.
Note that
the transducer must cover at least the span of the range
the x-axis has to be linear
the unit has to be dB
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<Transducer> String containing the transducer file name, including the path
information.
Manual operation: See " Transducer " on page 258
14.5.7.3 Configuring the List Evaluation
The following commands configure the list evaluation.
Configuring and Performing Measurements

Table of Contents

Other manuals for R&S FSV3000 Series

Related product manuals