R&S FSV3000 Series - Page 833

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
833User Manual 1178.8520.02 ─ 01
Useful commands for spurious emission measurements described elsewhere
●
MMEMory:STORe<n>:LIST on page 1085
Remote commands exclusive to spurious emission measurements
CALCulate<n>:ESPectrum:PSEarch:DETails.................................................................... 833
CALCulate<n>:ESPectrum:PEAKsearch:DETails...............................................................833
CALCulate<n>:PSEarch:AUTO....................................................................................... 833
CALCulate<n>:PEAKsearch:AUTO..................................................................................833
CALCulate<n>:PSEarch:MARGin.................................................................................... 834
CALCulate<n>:PEAKsearch:MARGin...............................................................................834
CALCulate<n>:PSEarch:PSHow......................................................................................834
CALCulate<n>:PEAKsearch:PSHow................................................................................834
CALCulate<n>:PSEarch:SUBRanges...............................................................................834
CALCulate<n>:PEAKsearch:SUBRanges.........................................................................834
CALCulate<n>:ESPectrum:PSEarch:DETails <State>
CALCulate<n>:ESPectrum:PEAKsearch:DETails <State>
This command configures how detailed the list in the Result Summary is.
Suffix:
<n>
.
Window
Parameters:
<State> ON | OFF | 1 | 0
ON | 1
Includes all detected peaks (up to a maximum defined by
CALCulate<n>:PEAKsearch:SUBRanges on page 834).
OFF | 0
Includes only one peak per range.
*RST: 0
Example:
CALC:ESP:PSE:DET ON
CALC:PSE:SUBR 10
Includes up to 10 peaks per range in the list.
Manual operation: See " Details " on page 261
CALCulate<n>:PSEarch:AUTO <State>
CALCulate<n>:PEAKsearch:AUTO <State>
This command turns the list evaluatio
n on and off.
Suffix:
<n>
.
Window
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Configuring and Performing Measurements