R&S FSV3000 Series - Page 859

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
859User Manual 1178.8520.02 ─ 01
Remote commands exclusive to harmonic distortion measurements
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:BANDwidth:AUTO...............................859
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:NHARmonics......................................859
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:PRESet..............................................859
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:BANDwidth:AUTO <State>
This command selects the resolution bandwidth of the harmonic in respect to the band-
width of the first harmonic.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
identical
ON | 1
a multiple
*RST: 1
Manual operation: See " Harmonic RBW Auto " on page 290
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:NHARmonics <NoHarmonics>
This command selects the number of harmonics that the R&S FSV/A looks for.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<NoHarmonics> Range: 1 to 26
*RST: 10
Manual operation: See " Number of Harmonics " on page 290
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:PRESet
This command initiates a measurement to determine the ideal configuration for the har-
monic distortion measurement.
The method depends on the span.
●
Frequency domain (span > 0)
Frequency and level of the first harmonic are determined and used for the mea-
surement list.
●
Time domain (span = 0)
The level of the first harmonic is determined. The frequency remains unchanged.
Configuring and Performing Measurements