EasyManua.ls Logo

R&S FSV3000 Series - Page 860

R&S FSV3000 Series
1268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
860User Manual 1178.8520.02 ─ 01
Suffix:
<n>
.
Window
<m> Marker
Manual operation: See " Adjust Settings " on page 290
14.5.10.3 Performing the Measurement
The following commands are required to perform a harmonic distortion measurement:
INITiate<n>[:IMMediate] on page 747, see Chapter 14.5.1, "Performing Mea-
surements", on page 745
14.5.10.4 Retrieving Results
The following commands retrieve the results of the harmonic distortion measurement.
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:DISTortion?........................................ 860
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:LIST...................................................860
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:DISTortion?
This command queries the total harmonic distortion of the signal.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also INITiate<n>:CONTinuous on page 746.
Suffix:
<n>
.
Window
<m> Marker
Query parameters:
<Result> TOTal
Return values:
<DistortionPct>
<DistortionDb>
Usage: Query only
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:LIST
This command queries the position of the harmonics.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also INITiate<n>:CONTinuous on page 746.
Configuring and Performing Measurements

Table of Contents

Other manuals for R&S FSV3000 Series

Related product manuals