R&S FSV3000 Series - Page 900

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
900User Manual 1178.8520.02 ─ 01
Suffix:
<n>
.
irrelevant
<t> irrelevant
Parameters:
<ReferenceLevel> The unit is variable.
Range: see datasheet
*RST: 0 dBm
Default unit: DBM
Example:
DISP:TRAC:Y:RLEV -60dBm
Manual operation: See " Reference Level " on page 370
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel:OFFSet <Offset>
This command defines a reference level offset (for all traces in all windows).
Suffix:
<n>
.
irrelevant
<t> irrelevant
Parameters:
<Offset> Range: -200 dB to 200 dB
*RST: 0dB
Default unit: DB
Example:
DISP:TRAC:Y:RLEV:OFFS -10dB
Manual operation: See "Shifting the Display ( Offset )" on page 274
See " Shifting the Display ( Offset )" on page 370
[SENSe:]POWer:NCORrection <State>
This command turns noise cancellation on and off.
If noise cancellation is on, the R&S FSV/A performs a reference measurement to
determine its inherent noise and subtracts the result from the channel power measure-
ment result (first active trace only).
For more information see " Noise Cancellation " on page 161.
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
POW:NCOR ON
Manual operation: See " Noise Cancellation " on page 161
14.7.3.2 Configuring the Attenuation
INPut<ip>:ATTenuation...................................................................................................901
INPut<ip>:ATTenuation:AUTO......................................................................................... 901
Setting Basic Measurement Parameters