EasyManua.ls Logo

R&S FSV3000 Series - Page 975

R&S FSV3000 Series
1268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
975User Manual 1178.8520.02 ─ 01
FORMat[:DATA] <Format>[, <BitLength>]
This command selects the data format that is used for transmission of trace data from
the R&S FSV/A to the controlling computer.
Note that the command has no effect for data that you send to the R&S FSV/A. The
R&S FSV/A automatically recognizes the data it receives, regardless of the format.
For details on data formats see Chapter 14.8.2.5, "Formats for Returned Values: ASCII
Format and Binary Format", on page 977.
Parameters:
<Format> ASCii | REAL | UINT | MATLab
ASCii
ASCii format, separated by commas.
This format is almost always suitable, regardless of the actual
data format. However, the data is not as compact as other for-
mats may be.
REAL
Floating-point numbers (according to IEEE 754) in the "definite
length block format".
<BitLength> 16 | 32 | 64
Length in bits for floating-point results
32
32-bit floating-point numbers
For I/Q data, 8 bytes per sample are returned for this format set-
ting.
Example:
FORM REAL,32
TRACe<n>[:DATA]
This command queries current trace data and measurement results.
The data format depends on FORMat[:DATA] on page 975.
Suffix:
<n>
.
Window
Query parameters:
<ResultType> Selects the type of result to be returned.
TRACE1 | ... | TRACE6
Returns the trace data for the corresponding trace.
SPECtrogram | SGRam
Returns the results of the spectrogram result display.
For details see Table 14-6.
Example:
TRAC? TRACE3
Queries the data of trace 3.
Analyzing Measurements (Basics)

Table of Contents

Other manuals for R&S FSV3000 Series

Related product manuals